No. |
Product |
Photo |
1 |
|
| |
The sharp, small chip being mixed in the cutting lubricants, it scatters, under bad environment of cutting actual place and the like with the sensor of standard specification, it is not possible possibly to correspond.
The pioneer of the edge sensor fo |
|
|
| |
|
|
|
 |
2 |
|
| |
The edge sensor for the CNC lathe is used for the position detection of the byte edge. When it applies the edge to the contact and pushes, on→OFF touch signal whose repeatability is good is output by CNC and PC, edge position is automatically writte |
|
|
| |
|
|
|
 |
3 |
|
| |
Installing in the CNC machine tool of machining center, the milling machine, the boring board and the drilling machine etc, precise position detection of edge such as drill, end mill and cutter (pre-setting), it is used for wearing, breaking and inspectin |
|
|
| |
|
|
|
 |
4 |
|
| |
*This product is compatible with the D5F type of OMRON
*Metrol supplies CNC sensors to the CNC Builder in the same manner as OMRON series.
|
|
|
| |
|
|
|
 |
5 |
|
| |
Product range: Tool setters for CNC lathes , Tool setters for CNC machining centers , Work sensors for CNC Machine tool & Drill Bit Breakage Detection Sensor |
|
|
| |
|
|
|
 |
6 |
|
| |
Product range: Tool setters for CNC lathes , Tool setters for CNC machining centers , Work sensors for CNC Machine tool & Drill Bit Breakage Detection Sensor
|
|
|
| |
|
|
|
 |
7 |
|
| |
The edge sensor for the CNC lathe is used for the position detection of the byte edge. When it applies the edge to the contact and pushes, on→OFF touch signal whose repeatability is good is output by CNC and PC, edge position is automatically writte |
|
|
| |
|
|
|
 |
